/var/www/restricted/ssh/stm32/www/stm32circle/ STM CircleOS forum / Application of MQ2 Smoke Sensor Module Based on STM32 Spruce

Username:     
Password:     
             

Forum
  • Index
  •  » STM32 primer
  •  » Application of MQ2 Smoke Sensor Module Based on STM32 Spruce

# 1   2011-09-23 07:46:09 Application of MQ2 Smoke Sensor Module Based on STM32 Spruce

daweizhang
New member
Registered: 2011-09-23
Posts: 1

Application of MQ2 Smoke Sensor Module Based on STM32 Spruce

This flammable gas and smoke sensor detects the concentrations of combustible gas in the air and ouputs its reading as an analog voltage. The sensor can measure concentrations of flammable gas of 300 to 10,000 ppm.The sensor can operate at temperatures from -20 to 50°C and consumes less than 150 mA at 5 V.

Connecting five volts across the heating (H) pins keeps the sensor hot enough to function correctly. Connecting five volts at either the A or B pins causes the sensor to emit an analog voltage on the other pins. A resistive load between the output pins and ground sets the sensitivity of the detector. Please note that the picture in the datasheet for the top configuration is wrong. Both configurations have the same pinout consistent with the bottom configuration.The resistive load should be calibrated for your particular application using the equations in the datasheet, but a good starting value for the resistor is 20 kΩ.

You can find more information the following link:
SolidDigi Optical Fingerprint Module for Arduino
Next:No Information

Last edited by daweizhang (2011-09-23 07:52:44)

Offline

 

  • Index
  •  » STM32 primer
  •  » Application of MQ2 Smoke Sensor Module Based on STM32 Spruce

Board footer